Posts: 1
Joined: Fri Feb 17, 2012 7:36 pm
Location: USA
Contact: Website

Setting output Decimal Places for Meter values

Fri Feb 17, 2012 7:42 pm

On Fri, 17 Feb 2012, lesterc@cannoncorp.us wrote:
> Hello: I have been using CoordTrans for a couple of years. Recently we needed to convert Lambert Zone 5 coordinates in feet, to UTM Zone 10 in meters. The transform worked very well, except the UTM coordinates only reported out to 2 decimal places. To maintain relative/calculated accuracy, I felt the meter coordinates should have been listed to 4 decimal places. I could not find a Tool or setup option to change this? Greatly appreciate your assistance.
> Lester E. Carter Jr., PLS 6148
> Director of Surveys
> Cannon
> 1050 Southwood Drive
> San Luis Obispo, CA 93401
> Ph: 805-503-4522
> lesterc@CannonCorp.us

Lester E. Carter Jr.PLS
Director of Surveys
1050 Southwood Drive
San Luis Obispo CA 93402

Return to “CoordTrans”