Posts: 1
Joined: Fri Jan 25, 2019 8:40 pm

Concox AT4 commands

Fri Jan 25, 2019 8:58 pm

Having a problem with a Concox AT6 (3g) which uses the same sms commands as the AT4 (2g) unit - I've set the ip address and the port to my server/port address, GPSGate is talking to it via terminal, but Vehicle Tracker always has it either as "pending" or "offline" - If I send a "POSITION#" command via sms from my phone, I get the following response "Currently, GNSS is not positioning, please try again later"

I'm pulling my hair out trying to get this tracker to work and am not having much luck! HELP!!!

Posts: 89
Joined: Fri Jul 25, 2014 6:18 pm

Re: Concox AT4 commands

Mon Jan 28, 2019 3:02 pm

It sounds like it is not getting GPS signal or is in sleep mode
Try shaking the device outside to wake it up and get signal

Return to “GPS trackers, AVL hardware, SIM subscriptions etc.”