Page 1 of 1

GL300 Mapping Variable

Posted: Wed May 28, 2014 4:07 am
by sowmach
Hi,

I Have a GL300 , Function Key its configured on 1 (Geofence Mode).
So when I click on the function key it sends the following:

+RESP:GTSWG,1A0102,860599000039511,GL300,0,0,,0,1613.4,-103.416843,20.727585,20140523165158,0334,0020,091C,29F5,,20140523165159,736B$

+RESP:GTSWG,1A0102,860599000039511,GL300,1,0,,0,1615.1,-103.416857,20.727493,20140523165358,0334,0020,091C,29F5,,20140523165409,7371$

I want to have an event rule, when this gets activated, and another one when this gets deactivated.

The problem is that on device mapper I have selected Geofence ID (it only allows analog mapping), to Acceleration. and in the event rule I have selected Acceleration as the variable, but it doesnt appear to work... can anyone help me?

RE: GL300 Mapping Variable

Posted: Thu May 29, 2014 2:25 pm
by johan
We have now added an input GeoActive to the GL300 device mapper.

Please update SensorLogic under SiteAdmin -> Plugins and test.

Regards,
Johan

GpsGate Support

Re: GL300 Mapping Variable

Posted: Sat Jan 21, 2017 7:19 am
by jmtces
I have just bought a GL300 and there was no manual with SMS commands supplied. I have searched and downloaded every Queclink manual I could find trying to find how to send commands to the GL300 with no luck. I would appreciate if someone could send me the manual or a link to the manual or just a list of commands and parameters. I also have a Prolific USB to Serial adapter that will accept the trackers USB cable for terminal communication. Please help?

James Taylor