Using brackets [ ] in a command template

[flap_152]

The command I'm trying to implement is this:

Code: Select all

[begin]sms2,*status*,[end]

[begin] and [end] are literals and not variables. How should I include them in the template?

In the terminal window, I successfully used ASCII codes like this:

Code: Select all

[0x5B]begin[0x5D]sms2,*status*,[0x5B]end[0x5D]

But it does not seem to work as a command template

[johan]

What does the Terminal data look like when you send that Template Command?

[flap_152]

Terminal excerpt showing 2 messages sent. One device response causes a parsing error but this issue has been reported to support.

[2018-12-04 15:59:37] (184.151.112.18:7684/VJoy/tcp) Disconnect
[2018-12-04 15:59:37] (184.151.112.18:7684/VJoy/tcp) Error: Object reference not set to an instance of an object.
[2018-12-04 15:59:37] (184.151.112.18:7684/VJoy/tcp) Client: (864768011321301,ZC03,041218,205936,$1 .Sensor sensitivity: 1[0x0D][0x0A]2 .Alert status: CALL[0x0D][0x0A]3 .Check interval is set to 3 minute(s).[0x0D][0x0A]4 . Power: 62%[0x0D][0x0A]$)
[2018-12-04 15:59:33] (184.151.112.18:7684/VJoy/tcp) Server: [begin]sms2,*status*,[end]
[2018-12-04 15:59:13] (184.151.112.18:7684/VJoy/tcp) Client: (864768011321301,ZC03,041218,205912,$Notice: Cell Phone 5277 is set to master controller, the password is 123456.$)
[2018-12-04 15:59:10] (184.151.112.18:7684/VJoy/tcp) Client: (864768011321301,ZC01,041218,205909,123456,5277)
[2018-12-04 15:59:06] (184.151.112.18:7684/VJoy/tcp) Server: [begin]sms2,*master*123456*5277*,[end]

This is done using

[0x5B]begin[0x5D]sms2,*status*,[0x5B]end[0x5D]
and
[0x5B]begin[0x5D]sms2,*master*123456*5277*,[0x5B]end[0x5D]

[flap_152]

Maybe you meant the actual window....

Capture1111.JPG (90.61 KiB) Viewed 1446 times