In the administration page of gpsgate at the template command page, are printed examples of command parameters, for example :
Variables to be used in Template. A template like "$[DeviceIMEI],3,9" will result in a command like "$35930200541954114,3,9". Variables should be enclosed by brackets .
[SmsProxyPhoneNumber] Phone number to GpsGate Server SMS
[ProtocolHostname] Server address.
[ProtocolIPAddress] Server IP address
[ProtocolPortTcp] Server TCP port.
[ProtocolPortUdp] Server TCP port.
[DeviceImei] The IMEI of the device.
[DevicePhoneNumber] Phone number of device.
[Transport] Transport device should use. e.g. "tcp"
GPRS network parameters:
[GprsApn] APN for GPRS network deslected for device.
[GprsUsername] GPRS username.
[GprsPassword] GPRS password
[GprsDns1] GPRS DNS
[GprsDns2] GPRS DNS backup
Variables from Track Recorder:
[TimeFilter] Suggested update interval for tracking. In seconds
[SmsTimeFilter] Suggested update interval for SMS tracking. In seconds
[DistanceFilter] Suggested distance interval for tracking. In meters
[DirectionFilter] Suggested heading change for tracking. In degrees
[Motion] "1" for suggested motion based tracking. Else "0".
in my tracker TK102, for send command to the tracker is needed a password, ( the 123456 default password of tracker for example ), my question is, wich is the internal variabile of gpsgate program to add the password of device to template command ?