Page 1 of 1

Skip Pairing (or send as a binary value)

Posted: Tue May 26, 2009 1:41 am
by aaronu7
Hello, I was wondering if there is a way to to Bond to a device (Pair) with a binary value instead of an ASCII pin? Alternatively is it possible to "Skip pairing" which is possible when configuring a widcomm device in the wizard?

RE: Skip Pairing (or send as a binary value)

Posted: Tue May 26, 2009 1:45 pm
by Jonas
To my knowledge this is not possible with BlueTools.

Regards,
Jonas