aaronu7
Posts: 1
Joined: Tue May 26, 2009 1:38 am

Skip Pairing (or send as a binary value)

Tue May 26, 2009 1:41 am

Hello, I was wondering if there is a way to to Bond to a device (Pair) with a binary value instead of an ASCII pin? Alternatively is it possible to "Skip pairing" which is possible when configuring a widcomm device in the wizard?

Jonas
Posts: 2319
Joined: Mon Jan 09, 2006 2:20 pm
Location: Sweden

RE: Skip Pairing (or send as a binary value)

Tue May 26, 2009 1:45 pm

To my knowledge this is not possible with BlueTools.

Regards,
Jonas

Return to “BlueTools”