Page 1 of 1

Bonding

Posted: Thu Dec 04, 2008 8:49 pm
by rethicus
Hi Jonas,

I need your assistance for the following request. From the computer you request a Bond to a device, but without knowing the bonding code (actually the method Bond() requires an pincode). The device introduces the code, the system validates it and displays the right content to the user.

Exists any way to do this with the current version?

Thanks.

RE: Bonding

Posted: Thu Dec 04, 2008 8:59 pm
by Jonas
You cannot do this with BlueTools. You can only request a bonding, you cannot acknowledge it.
This is a limitation in the available stack commands afaik, since this would potentially allow anyone to make a bluetooth virus.


Regards,
Jonas

RE: Bonding

Posted: Fri Dec 05, 2008 3:48 pm
by rethicus
Ok, i guess i have to say no to the user request.

Thanks for quick answer.