deathprincess
Posts: 8
Joined: Wed Nov 19, 2008 8:08 am
Location: Philippines

Send using ObexObjectPush

Fri Nov 21, 2008 7:31 am

Hi guys,

I need help in identifying send status. Im using obex error code do determine the status returned after every send. the problem is that, it only works for sony ericsson. When i tried it using nokia, it returns a bluetoolsexcption not obex. Does this depend on the device class? I noticed that smart phones are prompted to download during the call of remote service stream while sony ericsson, device class is phone, is prompted on the objectpush.pushfile.

Jonas
Posts: 2319
Joined: Mon Jan 09, 2006 2:20 pm
Location: Sweden

RE: Send using ObexObjectPush

Fri Nov 21, 2008 9:22 am

That is dependent on how the manufacturer has implemented Obex at their end. If you get an ObexException it means that there were a problem during the handshake (in the protocol). If you get a BlueTools exception it means it was a problem in the physical link.

Regards,
Jonas

Return to “BlueTools”