Page 1 of 1

Show only paired devices

Posted: Fri Nov 14, 2008 8:06 pm
by michael29
Hello,

is it possible to show only already paired devices, without discovering with BlueTools?
I have the problem, that the discovering process takes to much time for my application and it would be fine if there's a possibility.

P.S:
Currently I'm using the BlueTools under a HQ iPaQ PPC wich is using the WidComm-Stack.

Thanks in advance.

RE: Show only paired devices

Posted: Fri Nov 14, 2008 8:15 pm
by Jonas
The Devices array will contain all devices that are cached, but I think you need to run the device discovery once to fill it.

Regards,
Jonas