Hi,

Any plans to add camera support to the Android app.

Thanks

I still do not believe that drones can do a proper job for deliveries.. it needs at least 5 years and many regulations. a good start for you will be here http://ardupilot.com

Regards

Hi,

You wrote "full automated delivery drone for pilot study". Please explain more. ie what is the drone supposed to do?

rgds

Hi Robert: The casing of the drone is not of importance here. What i mentioned above is for the Teltonika FM1100 casing that you should remove and place the PCB of FM1100 only inside the drone casing. This will allow you to monitor your drone using GPSGATE. As for the Aduino part, well you need to r...

Hi, Use the Teltonika FM1100. Remove its plastic casing and solder the drone 7.4 v or 11.1 v to the board directly. It is a very small unit and fits properly for a drone. Also, u need to shorten the GPS antenna cable length (easy to do) or you can use an Arduino micro-controler board with XBEE 900 P...

It is still there and not deleted. Please note all other device mapper like fm1100 etc are working.

Thanks

Hi,

The device mapper is not appearing in GGS for Teltonika FM2200. However, all other Teltonika models appear normal. Any advice please.

Thanks

Hi,

Anybody has the Windows 7 driver from Falcom Fox-in. Appreciate the help.

Thanks

If you send SMS command to FM1100 please use two empty spaces before the command if no user and password defined with the configurator. Ex : [][]getstatus. However, in GGS terminal just put the command as is. No need for empty spaces.

Hope this helps.

Thanks for the reply. Yest it is up to date.

Regards

Hi.. We are using Teltonika Temperature sensor with FM1100, however the GGS gate reading is different from the RAW data send by the device and sensor. Example RAW data sent -14 degrees, GGS is displaying +200 degrees. Also, everytime GGS is displaying different readings.. Any suggestions please. Reg...

Like I mentioned the firmware has to be obtained directly from Teltonika. You should provide them with the IMEI of the device. If they send you, you can use the updater application to update the new firmware. Please note if during firmware update, the device should never disconnects or loose power o...

@ divya

You need to obtain a special firmware from Teltonika to be able to use TCP commands. FM2200 uses SMS commands for configuration with its existing firmware.

Regards

You need to contact teltonika and give them the IMEI of your device then they will send you the firmware (provided that you are a reseller...)

rgds

Hi..

You need to get a new firmware if you want to use i-button with FM4200. Use FM1100 which has the i-button feature built in already.

rgds