Kerem
Posts: 23
Joined: Tue Mar 11, 2014 10:47 am
Location: Sweden
Contact: Website

GUIDE: Setup Eco Report with Cellocator

Fri Oct 03, 2014 2:49 pm

ECO Report configuration for Cellocator Cello-IQ

This guide shows how you configure your Cello-IQ device and GpsGate Server to monitor harsh driving, speeding and turning using the Eco Report Plugin.


1. Prerequisites

You have a GpsGate Server installation with a Cellocator device listed above (this guide does not cover basic device setup).

Verify that:

  • Your GpsGate Server is updated with the latest Cellocator and VarPack2 Plugins

  • The device is mounted according to recommendations from the manufacturer



2. Device Setup: Sudden Course Changed and Sudden Speed Change sensors

Description: Sudden Course Change and Sudden Speed Change sensors are derived from the GPS output; they analyse the delta speed and course between GPS fixes.

Cellocator devices require you to define speed ranges and thresholds by programming the corresponding bytes on device's EEPROM. You will have to program 4 speed ranges, and also speed/course thresholds for each range separately. For more information on EEPROM byte mapping, please check Cellocator Cello Programming Manual section 7.3 - Sudden Course Changed and Sudden Speed Change sensors for more detailed information.

In order to program the EEPROM on the device, you must follow the instructions in Cellocator Integration Package [Full Edition] section 9.2 Programming Command - Message Type 1. This section goes through all the steps for how to write programming data into the device's memory.


3. Application setup: Configure the Device mapper

Login to VehicleTracker as an administrator.

Select the Cello-IQ device mapper and map the following signals:

"HarshAcceleration" = "HarshAccelerationDigital"
"HarshBraking" = "HarshBreakingDigital"
"HarshTurning" = "HarshTurningDigital"
"Ignition" = "Ignition"

Save the Device mapper.


4. Application setup: Install ECO Report Plugin

Follow this setup guide to install the Eco Report Plugin:
http://gpsgate.com/blogComment/eco_report_setup

How to connect SensorLogic devices to GpsGate Server
http://forum.gpsgate.com/topic.asp?TOPIC_ID=10248

Regards,
Kerem

GpsGate Support

Return to “GpsGate Server - How to setup and use”