User avatar
Henrik
GpsGate
Posts: 229
Joined: Thu Jul 26, 2007 8:41 pm
Location: Sweden
Contact: Website

GUIDE: Setup Eco Report with SensorLogic/Queclink

Mon Jun 24, 2013 6:42 pm

ECO Report configuration for SensorLogic (Queclink) GV200

This guide shows how you configure your SensorLogic device and GpsGate Server to monitor harsh driving, speeding and excessive idling using the Eco Report Plugin.

1. Prerequisites

You have a GpsGate Server installation with a SensorLogic device listed above (this guide does not cover basic device setup).

Verify that:
  • Your GpsGate Server is updated with the latest SensorLogic and VarPack2 Plugins

  • The device is mounted according to recommendations from the manufacturer


2. Device setup: Harsh driving

You can start with these acceleration and breaking settings, or change it to values that suit you better:

High speed (over 100km/h)
Harsh braking: 21 km/h change in 5 seconds.
Harsh acceleration: 6 km/h change in 5 seconds.

Medium speed (between 60km/h and 100km/h)
Harsh braking: 21 km/h change in 5 seconds.
Harsh acceleration: 6 km/h change in 5 seconds.

Low speed (below 60km/h)
Harsh braking: 21 km/h change in 5 seconds.
Harsh acceleration: 15 km/h change in 5 seconds.

Send this command to set the harsh braking and acceleration values shown above (using the default password "gv200"):
AT+GTHMB=gv200,1,,,100,21,6,,60,21,6,,,21,15,,0,0,0,0,,,,,0017$

The command has the following format:
AT+GTHMB=<password>,1,,,<high speed>,<brk_limit>,<acc_limit>,,<medium_speed>,<brk_limit>,<acc_limit>,,,<brk_limit>,<acc_limit>,,<output_id>,<output_status>,<duration>,<toggle_times>,,,,,0017$

(The Password is set to "gv200" in the sample command)


Note: The <GPS On Need> variable must have its default value 0. This can be set using the AT+GTCFG command if required.

3. Application setup: Configure the Device mapper

Login to VehicleTracker as an administrator.

Select the GV200 device mapper and map the following signals:

"HarshAcceleration" = "HarshAccelerationDigital"
"HarshBraking" = "HarshBreakingDigital"
"Ignition" = "Ignition"

Save the Device mapper.

4. Application setup: Install ECO Report Plugin

Follow this setup guide to install the Eco Report Plugin:
http://gpsgate.com/blogComment/eco_report_setup

How to connect SensorLogic devices to GpsGate Server
http://forum.gpsgate.com/topic.asp?TOPIC_ID=10248

Regards,

Henrik
GpsGate Support

guilleestrella
Posts: 2
Joined: Wed Aug 31, 2016 12:30 am

Re: GUIDE: Setup Eco Report with SensorLogic/Queclink

Fri Sep 02, 2016 10:50 pm

Hi Hendrik, we use GV300W instead of GV200. What is the device setup for a GV300W ???

Return to “GpsGate Server - How to setup and use”