User avatar
Henrik
GpsGate
Posts: 229
Joined: Thu Jul 26, 2007 8:41 pm
Location: Sweden
Contact: Website

GUIDE: Setup Eco Report with WondeProud

Thu May 16, 2013 5:42 pm

ECO Report configuration for WondeProud VT10

This guide shows how you configure your WondeProud devices and GpsGate Server to monitor harsh driving, speeding and excessive idling using the Eco Report Plugin.

1. Prerequisites

You have a GpsGate Server installation with a WondeProud device listed above (this guide does not cover basic device setup).

Verify that:
  • Your GpsGate Server is updated with the latest WondeProud and VarPack2 Plugins

  • The device is mounted according to recommendations from the manufacturer


2. Device setup: Harsh driving

You can start with these acceleration and breaking settings, or change it to values that suit you better:
Harsh acceleration: 10 km/h change in 2 seconds.
Harsh breaking: 10 km/h change in 2 seconds.

Send this command to set the harsh acceleration values shown above:
$WP+HA=0000,2,10,2

Send this command to set the harsh breaking values shown above:
$WP+HB=0000,2,10,2

The commands have the following format:
$WP+HA+[TAG]=[Password],[Mode],[Speed Increase Threshold],[Duration]
$WP+HB+[TAG]=[Password],[Mode],[Speed Increase Threshold],[Duration]

(The Password is set to "0000" in the samples above)



3. Application setup: Configure the Device mapper

Login to VehicleTracker as an administrator.

Select the WondeProud device mapper for your device and map the following signals:

"HarshAcceleration" = "HarshAccelerationDigital"
"HarshBraking" = "HarshBreakingDigital"
"Ignition" = "Ignition"

Save the Device mapper.

4. Application setup: Install ECO Report Plugin

Follow this setup guide to install the Eco Report Plugin:
http://gpsgate.com/blogComment/eco_report_setup

How to connect WondeProud devices to GpsGate Server
http://forum.gpsgate.com/topic.asp?TOPIC_ID=11613

Regards,

Henrik
GpsGate Support

Return to “GpsGate Server - How to setup and use”