User avatar
david
GpsGate
Posts: 5
Joined: Wed Mar 30, 2016 4:10 pm
Location: Sweden

Setup GL300-Queclink with Template Commands

Fri Jun 30, 2017 10:06 am

Preparation
1.Follow the guide http://forum.gpsgate.com/viewtopic.php?t=10248

2.Make sure the device:
-has the SIM card inserted,
-is switched on,
-has GPS fix position (blue light GPS indicator constantly on->place it in the open air)

3.Make sure SMS is enabled.

Run template commands for GL300
Configure your device to send data to your server by following steps 1-2 below, (3-6 optional)
1.Right-clic on the device and press on "GprsSetupGL300" to connect to the server.
2.Right-clic on the device and press on "StartTrackingGL300" to start tracking.

3.Optional: Consult the documentation and send commands to configure the device according to your needs.
4.Optional: Test by sending e.g. the "StopTrackingGL300" command. The device should now stop sending track reports. Open a terminal and observe the changes.
5.Optional: Save power after GL300 is configured by changing report mode to 1 from 3 by sending the "ChangeReportModeTo1" command.
6.Optional: Run "StartTrackingGL300" again whenever you want to continue configuring your device.

Terminal: http://gpsgate.com/blogComment/send_commands_and_diagnose_your_terminal_data_using_terminal_window
Template Commands: http://forum.gpsgate.com/viewtopic.php?t=10220
David

Return to “Supported GPS tracking devices”