vol.and
Posts: 3
Joined: Fri Aug 04, 2017 8:34 am

Teltonika FM5300 external battery voltage

Fri Aug 04, 2017 10:59 am

Gentlemen,
I need advice how to map FM5300 to get external battery voltage.

"I/O Element Number I/O element parameters
I/O#17 – Ext. Voltage 470 – 475"

multitechsb
Posts: 98
Joined: Mon Aug 02, 2010 12:20 pm
Location: Malaysia
Contact: Website

Re: Teltonika FM5300 external battery voltage

Thu Aug 10, 2017 8:24 am

You need to first check which is the active profile used by the device Eg. Profile 3 or Profile 4. You then need to ensure that the I/O parameters for that particular profile are enabled. For example if you are configuring by sms, then you can check by " getparam 3470" . This assumes profile 3 is being used. After you get a reply from the device, for example Param ID:3470 Val:0, then you can issue the sms command " setparam 3470 1" This will enable the I/O parameter for External Power Supply (Vehicle Battery) for Profile 3. You do the same for 3471, 3472,3473,3474. If you need the device to immediately transmit back the information once the External battery is disconnected, then you need to set 3471 to 1 (or High) or 2 (Panic). You can set 3472 to something like 9 (for 9 Volts) and 3473 to 0 (for 0 Volts). You can set 3474 to 1 (on Entrance). This means that once the External Voltage drops from 12 Volts to between 9 Volts and 0 Volts, the device will immediately transmit back it's position and status. In GpsGate, you need to select the Device Mapper for FM5300 and look for something like External Power Supply and map it to either Battery Voltage or Voltage.

vol.and
Posts: 3
Joined: Fri Aug 04, 2017 8:34 am

Re: Teltonika FM5300 external battery voltage

Mon Aug 21, 2017 12:22 pm

multitechsb ,
Thank you for your answer,
I've already applied these settings, but and tracker shows only internal battery voltage (9.5 - 9.7 V).
I've tested it with the different platform and it was Ok.
I think the 'External battery voltage' is not mapped in 'Telotnika' plug in, so "ve to map it manually.

multitechsb
Posts: 98
Joined: Mon Aug 02, 2010 12:20 pm
Location: Malaysia
Contact: Website

Re: Teltonika FM5300 external battery voltage

Mon Aug 28, 2017 8:45 am

It is mapped as "PowerSupplyVoltage"

vol.and
Posts: 3
Joined: Fri Aug 04, 2017 8:34 am

Re: Teltonika FM5300 external battery voltage

Thu Aug 31, 2017 10:05 am

Thanks!!! Problem solved.

Return to “GPS trackers, AVL hardware, SIM subscriptions etc.”